DYNAJET
Nozzle holder head TD08‑25°
DYNAJET nozzle holder head with TD08 designation and a 25° angle. Built as a dedicated accessory component for nozzle holder assemblies.
Working pressure should match the task. Surface preparation and general maintenance typically use 150 to 500 bar, while industrial coating removal and concrete work require higher pressure. Contact your nearest distribution partner for guidance on the right pressure and flow rate for your specific job.
DYNAJET high-pressure cleaners are built in Tjæreborg, Denmark, for daily professional use. Spare parts and service are available through our distribution partners. For warranty terms specific to your unit, contact your local distribution partner.
DYNAJET high-pressure cleaners are built to comply with applicable safety and emissions standards. Operators should always follow local safety regulations and use appropriate protective equipment.
DYNAJET is sold exclusively through distribution partners worldwide, giving operators local access to product expertise, spare parts and service. If you do not know your local partner, contact us directly and we will help you find the right support in your region.
Nozzle Holder Head TD08 with 25° Angle
This DYNAJET accessory is a nozzle holder head in TD08 configuration with a 25° angle. It is intended as a component within a nozzle holder setup.
The defined 25° version supports clear product selection where this angle specification is required. Its TD08 designation identifies the corresponding holder head variant within the DYNAJET accessory range.