DYNAJET
Nozzle holder head TD‑10‑35°
Nozzle holder head with a TD-10 designation and 35° angle. Built as a DYNAJET accessory for setups that require this head format and angled configuration.
Working pressure should match the task. Surface preparation and general maintenance typically use 150 to 500 bar, while industrial coating removal and concrete work require higher pressure. Contact your nearest distribution partner for guidance on the right pressure and flow rate for your specific job.
DYNAJET high-pressure cleaners are built in Tjæreborg, Denmark, for daily professional use. Spare parts and service are available through our distribution partners. For warranty terms specific to your unit, contact your local distribution partner.
DYNAJET high-pressure cleaners are built to comply with applicable safety and emissions standards. Operators should always follow local safety regulations and use appropriate protective equipment.
DYNAJET is sold exclusively through distribution partners worldwide, giving operators local access to product expertise, spare parts and service. If you do not know your local partner, contact us directly and we will help you find the right support in your region.
Nozzle holder head with TD-10 and 35° angle
This nozzle holder head is identified by the TD-10 designation and a 35° angle. It serves as a DYNAJET accessory component within a nozzle holder head configuration.
The angled 35° design is the defining visible feature, alongside the TD-10 reference. For product selection and replacement, these two details provide a clear basis for matching the required head version.