DYNAJET
High‑pressure hose, NW8 × 870, 2×90°, BSP 60°, 400 bar
This hose accessory belongs to the Hoses category and is specified with NW8, 870 length and 2x90° ends. The BSP 60° connection detail defines the hose configuration for matching the correct high-pressure line.
Working pressure should match the task. Surface preparation and general maintenance typically use 150 to 500 bar, while industrial coating removal and concrete work require higher pressure. Contact your nearest distribution partner for guidance on the right pressure and flow rate for your specific job.
DYNAJET high-pressure cleaners are built in Tjæreborg, Denmark, for daily professional use. Spare parts and service are available through our distribution partners. For warranty terms specific to your unit, contact your local distribution partner.
DYNAJET high-pressure cleaners are built to comply with applicable safety and emissions standards. Operators should always follow local safety regulations and use appropriate protective equipment.
DYNAJET is sold exclusively through distribution partners worldwide, giving operators local access to product expertise, spare parts and service. If you do not know your local partner, contact us directly and we will help you find the right support in your region.
NW8 hose with 2x90° BSP 60° connections
This accessory is a high-pressure hose in NW8 size, specified with an 870 length and 2x90° end configuration. The BSP 60° thread detail identifies the connection geometry and helps distinguish this hose variant within the Hoses category.
It is intended for setups where these exact hose dimensions and end angles are required. The angled ends and defined connection specification support accurate selection when matching a replacement or configuring a DYNAJET hose assembly.