DYNAJET
High‑pressure hose, NW8 × 1250, 1×90°, BSP 60°, 400 bar
This high-pressure hose from the Hoses category is specified with NW8 and a length of 1250, with one 90° end and BSP 60° connection details. It is a hose accessory for defined high-pressure routing in DYNAJET setups.
Working pressure should match the task. Surface preparation and general maintenance typically use 150 to 500 bar, while industrial coating removal and concrete work require higher pressure. Contact your nearest distribution partner for guidance on the right pressure and flow rate for your specific job.
DYNAJET high-pressure cleaners are built in Tjæreborg, Denmark, for daily professional use. Spare parts and service are available through our distribution partners. For warranty terms specific to your unit, contact your local distribution partner.
DYNAJET high-pressure cleaners are built to comply with applicable safety and emissions standards. Operators should always follow local safety regulations and use appropriate protective equipment.
DYNAJET is sold exclusively through distribution partners worldwide, giving operators local access to product expertise, spare parts and service. If you do not know your local partner, contact us directly and we will help you find the right support in your region.
High-pressure hose with 90° and BSP 60° ends
This hose is identified by NW8 and a length of 1250, with one 90° end and BSP 60° connection detail. It belongs to the Hoses category and is specified as a high-pressure hose accessory for use in system layouts where the hose routing and end geometry matter.
The 90° end can support compact installation conditions, while the BSP 60° reference defines the connection format shown in the product name. For selection and replacement work, these visible dimensions and connection details are the relevant points of reference. The hose should be matched only against the specified technical data and the intended DYNAJET configuration.