DYNAJET
High‑pressure hose DN8, L = 20 m, PN1000, DKOS M24x1.5 – DKOS M24x1.5
This high-pressure hose in the Hoses category is specified at DN8 and 20 m. It is intended as a hose component for pressure washer setups where a defined hose size and length are required.
Working pressure should match the task. Surface preparation and general maintenance typically use 150 to 500 bar, while industrial coating removal and concrete work require higher pressure. Contact your nearest distribution partner for guidance on the right pressure and flow rate for your specific job.
DYNAJET high-pressure cleaners are built in Tjæreborg, Denmark, for daily professional use. Spare parts and service are available through our distribution partners. For warranty terms specific to your unit, contact your local distribution partner.
DYNAJET high-pressure cleaners are built to comply with applicable safety and emissions standards. Operators should always follow local safety regulations and use appropriate protective equipment.
DYNAJET is sold exclusively through distribution partners worldwide, giving operators local access to product expertise, spare parts and service. If you do not know your local partner, contact us directly and we will help you find the right support in your region.
DN8 hose with 20 m length for pressure systems
This hose is a DYNAJET accessory for the Hoses category, identified by DN8 and a length of 20 m. The designation points to a pressure-rated hose line used as part of a professional high-pressure setup.
With its defined nominal diameter and extended length, it serves as a hose section in systems where hose routing and reach matter. The product name does not provide further technical details, so any use should be based on the stated DN8 size and 20 m length only.