DYNAJET
High‑pressure hose DN5, L = 20 m, PN2800, 3/8‑24 UNF LH
High-pressure hose with DN5 designation and a length of 20 m for use as a DYNAJET accessory. The specified dimensions identify it as a pressure hose component for corresponding high-pressure setups.
Working pressure should match the task. Surface preparation and general maintenance typically use 150 to 500 bar, while industrial coating removal and concrete work require higher pressure. Contact your nearest distribution partner for guidance on the right pressure and flow rate for your specific job.
DYNAJET high-pressure cleaners are built in Tjæreborg, Denmark, for daily professional use. Spare parts and service are available through our distribution partners. For warranty terms specific to your unit, contact your local distribution partner.
DYNAJET high-pressure cleaners are built to comply with applicable safety and emissions standards. Operators should always follow local safety regulations and use appropriate protective equipment.
DYNAJET is sold exclusively through distribution partners worldwide, giving operators local access to product expertise, spare parts and service. If you do not know your local partner, contact us directly and we will help you find the right support in your region.
High-pressure hose DN5 in 20 m length
This high-pressure hose is a DYNAJET accessory with DN5 sizing and a total length of 20 m. It serves as a hose component within a high-pressure arrangement.
The DN5 designation defines the nominal size, while the 20 m length specifies the hose reach within the setup. Its clear dimensional specification supports precise product selection where hose size and length are relevant.