DYNAJET
High‑pressure hose DN10, L = 75 m, PN500, M24x1.5 – DKR90 G3/8
High-pressure hose with DN10 designation and a length of 75 m. As a DYNAJET accessory, it provides an extended hose section for high-pressure setups.
Working pressure should match the task. Surface preparation and general maintenance typically use 150 to 500 bar, while industrial coating removal and concrete work require higher pressure. Contact your nearest distribution partner for guidance on the right pressure and flow rate for your specific job.
DYNAJET high-pressure cleaners are built in Tjæreborg, Denmark, for daily professional use. Spare parts and service are available through our distribution partners. For warranty terms specific to your unit, contact your local distribution partner.
DYNAJET high-pressure cleaners are built to comply with applicable safety and emissions standards. Operators should always follow local safety regulations and use appropriate protective equipment.
DYNAJET is sold exclusively through distribution partners worldwide, giving operators local access to product expertise, spare parts and service. If you do not know your local partner, contact us directly and we will help you find the right support in your region.
High-pressure hose DN10 in 75 m length
This DYNAJET high-pressure hose is specified in DN10 and supplied in a 75 m length. It is part of the accessory range for high-pressure equipment and hose-based system configurations.
The combination of DN10 and 75 m identifies the hose size and overall length clearly, supporting selection where these dimensions are required within a professional high-pressure setup.