DYNAJET
High‑pressure hose DN10, L = 25 m, PN500, DKR G3/8 – DKR G3/8
High-pressure hose with DN10 nominal diameter and a 25 m length for integration into DYNAJET setups. The specified size supports clear product selection for hose routing and replacement.
Working pressure should match the task. Surface preparation and general maintenance typically use 150 to 500 bar, while industrial coating removal and concrete work require higher pressure. Contact your nearest distribution partner for guidance on the right pressure and flow rate for your specific job.
DYNAJET high-pressure cleaners are built in Tjæreborg, Denmark, for daily professional use. Spare parts and service are available through our distribution partners. For warranty terms specific to your unit, contact your local distribution partner.
DYNAJET high-pressure cleaners are built to comply with applicable safety and emissions standards. Operators should always follow local safety regulations and use appropriate protective equipment.
DYNAJET is sold exclusively through distribution partners worldwide, giving operators local access to product expertise, spare parts and service. If you do not know your local partner, contact us directly and we will help you find the right support in your region.
High-Pressure Hose DN10 in 25 m Length
This high-pressure hose is supplied in DN10 with a 25 m length. It is intended as a hose component within the DYNAJET accessory range.
The stated diameter and length provide the key reference points for selecting the right hose format for an existing setup. Suitable for replacement, extension planning or stock holding where DN10 and 25 m are required.