DYNAJET
Abrasive cutting head
A DYNAJET cutting head accessory for abrasive cutting setups. Built as a dedicated system component where a defined abrasive cutting head is required.
Working pressure should match the task. Surface preparation and general maintenance typically use 150 to 500 bar, while industrial coating removal and concrete work require higher pressure. Contact your nearest distribution partner for guidance on the right pressure and flow rate for your specific job.
DYNAJET high-pressure cleaners are built in Tjæreborg, Denmark, for daily professional use. Spare parts and service are available through our distribution partners. For warranty terms specific to your unit, contact your local distribution partner.
DYNAJET high-pressure cleaners are built to comply with applicable safety and emissions standards. Operators should always follow local safety regulations and use appropriate protective equipment.
DYNAJET is sold exclusively through distribution partners worldwide, giving operators local access to product expertise, spare parts and service. If you do not know your local partner, contact us directly and we will help you find the right support in your region.
Abrasive cutting head for DYNAJET systems
This abrasive cutting head is a DYNAJET accessory for abrasive cutting configurations. As a defined cutting head component, it forms part of the relevant setup where this product type is specified.
Its designation identifies it as a dedicated head for abrasive cutting. For professional DYNAJET equipment, it serves as a system component within the corresponding accessory and replacement parts range.